WorksPhysics and Astronomy
Raman-induced Kerr effect and heating in diamond
Abstract
We fully characterize the polarization-dependent third-order nonlinear susceptibility in a diamond crystal using phase-sensitive nondegenerate pump-probe spectroscopy near 1~m wavelength. Measuring the frequency-domain phase shift and amplitude change of the probe pulse as a function of polarization and probe wavelength allows direct extraction of the full anisotropic response, including the Raman contribution. We find that the polarization dependence of the two-beam coupling contribution for the Raman component differs from that predicted solely using one-beam selection rules. We measure a Kerr coefficient that is within the range of reported values in the literature, and our measured anisotropy parameters satisfy Kleinman symmetry, as expected. Our measured Raman polarizability agrees, after scaling for its dispersion, with a Brillouin-referenced measurement at 514.5~nm [Grimsditch and Ramdas, Phys. Rev. B 11, 3139 (1975)], but is lower than measurements from absolute Raman cross sections. The same technique could be used to measure other materials with relatively high phonon frequencies, and it complements measurements of the Kerr contribution of low-frequency modes using impulsive stimulated Raman scattering (ISRS). When the pump-probe difference frequency matches the phonon resonance, Raman-enabled two-photon absorption occurs; we directly measure the resulting heat deposition in diamond using time-resolved beam deflection of a continuous-wave laser. The measurement technique demonstrated here is capable of precise absolute measurements and will enable quantitative stimulated Raman heating microscopy, with potential extensions to thermal conductivity metrology.