WorksPhysics and Astronomy
High Characteristic Voltage YBCO Josephson Junctions Written With a Focused Helium Ion Beam
Abstract
We report in-plane Josephson junctions written directly into YBaCuO (YBCO) thin films with a focused helium ion beam (He FIB). The characteristic voltage of these junctions, where is the Josephson critical current and is the junction resistance, sets the operating frequency and the sensitivity of the circuits built from them. A single line irradiation with a dose of \SI{500}{ions/nm} across a \SI{4}{\micro\metre} wide electrode produced a junction with of 929 \si{\micro\volt} at \SI{1.6}{K}, which is `higher than the 200 to 400 \si{\micro\volt} typical of junctions fabricated previously in our laboratory. Temperature dependent resistance, current-voltage characteristics, magnetic field modulation of the critical current, and Shapiro steps under 20.5~GHz microwave irradiation show Josephson behavior with an excess current below 5 percent of the critical current. The critical current falls steeply with temperature near the junction transition and saturates at low temperature. We attribute this behavior to a barrier at the metal insulator transition, where hopping conduction through localized states is active at finite temperature and freezes out on cooling. We describe the changes in surface preparation, sample selection, beam focusing, and sample storage that accompanied the improvement, although the present data do not separate their individual contributions. Larger characteristic voltages at these dimensions are an encouraging result for rapid single flux quantum and adiabatic quantum flux parametron logic and for superconducting quantum interference devices operating at elevated temperature.