WorksPhysics and Astronomy
Experimental Evidence for Type-I Superconductivity in
Abstract
Since the discovery of superconductivity in , metal diborides have attracted significant attention. Among these, osmium diboride (), crystallizing in an orthorhombic structure (space group ) with puckered boron layers, has been classified as a low- Type-II superconductor (). Here, we report experimental evidence establishing that is in fact a rare nonelemental Type-I superconductor. Our identification is supported by three primary experimental hallmarks: (i) a pronounced Differential Paramagnetic Effect (DPE) peak in AC susceptibility () measurements under static DC magnetic fields, signaling the intermediate state; (ii) a field-induced crossover to a divergent first-order phase transition in specific heat (); and (iii) pronounced magnetic hysteresis in field-ramped transitions indicative of supercooling.
Introduction
The discovery of multi-gap superconductivity in MgB [1, 2] has stimulated renewed interest in research on transition-metal diborides [3, 4, 5, 6, 7, 8, 9]. Osmium and Ruthenium diboride crystallize in an orthorhombic structure with space group (No. 59), consisting of corrugated hexagonal boron layers stacked along the -axis between osmium planes [3, 4]. Early studies on polycrystalline and single-crystal samples established bulk superconductivity below K for OsB [3, 4] and K for RuB [3, 6]. OsB was historically assigned as a moderate-coupling, low- Type-II, electron-phonon-mediated superconductor with a Ginzburg-Landau parameter – [3, 4, 5].
Despite this Type-II classification, several experimental anomalies—including a reduced specific heat jump at (–), Type-I like magnetization curves , and an unusual concave curvature in the – phase boundary—prompted a re-examination of the nature of its superconducting state [3, 4, 5]. In particular, theoretical electronic structure calculations using density functional theory (DFT) and Shubnikov-de Haas oscillations revealed that OsB possesses multi-sheet Fermi surfaces with remarkably high Fermi velocities ( to cm/s) and almost free electron-like effective masses [4, 10, 11]. Because the BCS coherence length is directly proportional to the Fermi velocity,
the high Fermi velocities result in large coherence lengths (– nm), suppressing the Ginzburg-Landau parameter to – [10, 11]. These theoretical estimates place OsB deep inside the Type-I regime ().
Recently both OsB and RuB have been reported to be topological metals with topological surface states [8, 9]. Additionally, time reversal breaking has been observed on entering the superconducting state in RuB [9]. These recent discoveries have brought the question about the Type of superconductivity in these diborides in the limelight again.
In this paper, we present experimental evidence establishing OsB as a Type-I superconductor, joining a small group of binary intermetallics such as PdTe and YbSb [12, 13].
Experimental Methods
High-purity single crystals of OsB were synthesized via arc-melting and solution growth using a Cu-B flux as reported previously [3, 4]. The obtained crystals are thin hexagonal plates with width mm and thickness mm. Phase purity of the crystals was confirmed via powder X-ray diffraction (XRD). Dynamic AC magnetic susceptibility () was measured using the ac option in a physical property measurement system (PPMS-ECII). An ac field of 0.1 Oe at a frequency of 111 Hz was used to measure ac at various static dc fields applied parallel to the hexagonal plates. Specific heat at different temperatures and magnetic fields was recorded down to 1.7 K using a thermal relaxation technique in the PPMS. Data on two crystals (Xtal1 and Xtal2) from different growth batches have been used for heat capacity. The Xtal1 had a mass of 16 mg whereas Xtal2 had a mass of 4 mg. AC was measured on Xtal1.
Results and Discussion
Differential Paramagnetic Effect in AC Susceptibility
A defining signature of Type-I superconductivity is the formation of an intermediate state, where the material phase-separates into alternating normal and superconducting domains for applied fields , where is the critical field, and is the applied field. Within this field range, the differential susceptibility becomes positive. This phenomenon is called the differential paramagnetic effect and has been observed for example in several elemental Type-I superconductors [14].
Figure 1 shows the temperature dependence of the real component of AC susceptibility as a function of temperature under various static DC magnetic fields. To minimize demagnetization effects the crystal was oriented so that the dc magnetic field was in the ab-plane (parallel to the hexagonal crystal surface). As shown in Figure 1, while the zero-field measurements display a sharp diamagnetic drop at K, applying a modest DC magnetic field creates a prominent positive peak in just below the critical temperature. This positive Differential Paramagnetic Effect (DPE) peak is a signature of Type-I superconductors entering the intermediate state.

Figure 1. Differential Paramagnetic Effect (DPE). Real component of the AC susceptibility measured at 111 Hz under fixed DC magnetic fields ( Oe). In zero field, a sharp diamagnetic screening drop marks K. Under applied DC fields, a distinct positive DPE peak appears immediately prior to the normal-state transition, reflecting the positive slope characteristic of domain entry in the Type-I intermediate state.
Field-Induced First-Order Phase Transition
While zero-field superconducting transitions are second-order, Type-I superconductors in a finite magnetic field undergo a first-order phase transition accompanied by latent heat. We find this signature as well for OsB. Figure 2 displays the low-temperature specific heat measured at various applied magnetic fields for two crystals from different growth batches. The magnetic field was applied parallel to the -axis in these measurements.

Figure 2. First-order superconducting transition in magnetic fields. Temperature dependence of measured on two different crystals under various magnetic fields. At , the transition is a standard second-order jump with . Upon applying a magnetic field, the jump transforms into a sharp, divergent peak exceeding the zero-field amplitude, giving clear thermodynamic evidence for a field-induced first-order phase transition and latent heat.
In zero field, OsB displays a step-like anomaly at K consistent with previous reports [3, 4]. When a magnetic field is applied, the transition sharpens into a sharp peak where dramatically exceeds its zero-field value. This behaviour at the normal-superconductor transition confirms the latent heat absorption characteristic of a field-induced first-order phase transition.
Magnetic Hysteresis and Supercooling
Type-I superconductors are expected to exhibit supercooling in a magnetic field, where the normal state persists metastably below the critical field as the field is ramped downward. This can lead to hysteresis in the transition temperature as the magnetic field is increased or decreased through the normal-superconducting transition. Figure 3 shows field-ramped heat capacity transitions cycles measured at two different temperatures below . The hysteresis observed between field-up and field-down sweeps (Figure 3) confirms the presence of supercooling during the superconducting-to-normal phase boundary traversal.

Figure 3. Magnetic hysteresis and supercooling. Specific heat measured during field-increasing (black symbols) and field-decreasing (red symbols) sweeps at (a) K and (b) K. A clear hysteresis is observed in the normal-superconducting phase boundary indicating supercooling.
Conclusion
In summary, AC susceptibility, specific heat in fields, and field-ramping measurements across the normal-superconducting transition provide strong, unified evidence that OsB is a Type-I superconductor. The Differential Paramagnetic Effect (DPE), divergent specific heat anomaly in field, and field-ramping hysteresis confirm an intermediate state and first-order phase transition. These experimental observations are similar to recent reports on Type-I superconductivity in PdTe and YbSb [12, 13] and strongly suggest that OsB represents a rare example of a binary Type-I superconductor.
Acknowledgments
We thank the X-ray, the SEM, and the SQUID magnetometer facilities at IISER Mohali. We acknowledge DST, India, for support through grant CRG/2022/000015.
References
- [3]Y. Singh, A. Niazi, M. D. Vannette, R. Prozorov, and D. C. Johnston, Phys. Rev. B 76, 214510 (2007).
- [4]Y. Singh, C. Martin, S. L. Bud’ko, A. Ellern, R. Prozorov, and D. C. Johnston, Phys. Rev. B 82, 144532 (2010).
- [5]B. J. Suh, X. Zong, Y. Singh, A. Niazi, D. C. Johnston, Phys. Rev. B 76, 144511 (2007).
- [6]J. Singh, A. Jayaraj, D. Srivastava, S. Gayen, A. Thamizhavel, and Y. Singh Phys. Rev. B 97, 054506 (2018).
- [7]S. Datta, A. Vasdev, S. Halder, J. Singh, Y. Singh, and G. Sheet, J. of Phys.: Cond. Matt. 32, 315701 (2020).
- [8]N. S. Mehta, B. Patra, M. Garg, G. Mohmad, P. Bhardwaj, S. Chaudhary, J. Singh, Y. Singh, B. Singh, and G. Sheet, Phys. Rev. B 113, 134529 (2026).
- [9]R. Gupta, Reena, D. Samanta, J. Singh, T. J. Hicken, H. Luetkens, J. Krieger, S. K. Ghosh, and Y. Singh, https://doi.org/10.48550/arXiv.2610.26264 (2026).
- [10]J. Bekaert, S. Vercauteren, A. Aperis, I. Komendová, R. Prozorov, B. Partoens, and M. V. Milošević, Phys. Rev. B 94, 144506 (2016).
- [11]J. Bekaert, M. Milošević, and B. Partoens, Microscopic values of OsB2, Univ. Antwerp report (2015).
- [12]H. Leng, J.-C. Orain, A. Amato, Y. K. Huang, and A. de Visser, Phys. Rev. B 100, 224501 (2019).
- [13]Y. Gao, Z. Wang, and X. Chen, Phys. Rev. B 113, 075115 (2026).
- [14]R. A. Hein and R. L. Falge Jr., Phys. Rev. 123, 407 (1961).