WorksPhysics and Astronomy
Quantum-correlation of neutral charmed mesons at BESIII
Abstract
Quantum-correlated pairs give direct access to the strong-phase differences between and decays, which are essential inputs to the CKM angle and charm mixing. The BESIII experiment has accumulated the largest data sample at the resonance, corresponding to an integrated luminosity of . The neutral pairs produced at are in a -odd state. We report new and improved measurements of the strong-phase differences in , , and decays, alongside a measurement of the -even fraction in . Furthermore, we present a novel method that studies the quantum correlations using data collected at centre-of-mass energies from to GeV, where the pairs are produced in -even or -odd states, according to the number of accompanying photons. This gives the first observation of -even pairs and a new measurement of the strong-phase difference in decays.
Introduction
The Cabibbo-Kobayashi-Maskawa (CKM) angle is one of the least constrained angles and is the only angle of the Unitarity Triangle that can be measured in tree-level decays. Its direct determination, [1], is therefore a benchmark for the indirect determinations that involve loop processes, and the comparison between them can probe contributions from new physics. Such a direct measurement uses tree-level decays, in which is a superposition of and that decays to a common final state . The interference depends on and the strong-phase difference between the and amplitudes. The strong-phase differences also enter measurements of charm mixing and violation, such as the observation of a non-zero mass difference between the neutral charm-meson eigenstates [2].
Quantum-correlated pairs give access to the strong-phase differences directly. Hereafter, without superscript is a neutral of unspecified flavour, and charge conjugation is implied. At the , the neutral pair is produced in a -odd state, so the determination of the quantum state of one meson fixes the state of the other. The BESIII experiment has recorded the world’s largest data sample, , at the resonance. Above the threshold, BESIII has collected a data sample of at centre-of-mass energies of to GeV, where the pairs come from production and so are in both -even and -odd states. These data samples make BESIII a unique laboratory to study the strong-phase differences.
Strong-phase differences in decays
Updated model-independent binned measurement
The strong phase of varies significantly across the Dalitz plot, which makes this decay the most sensitive mode for and the charm-mixing parameter measurements. The BESIII experiment has measured the strong-phase parameters with a data sample of in three binning schemes with bins [3]. The decay serves as both a signal and a tag mode in this study. The earlier study linked the in with by introducing a difference from amplitude model prediction [4], which brings a weak model assumption here. In this analysis, a larger data sample is used and both results with and without this model assumption are presented, both provide the most precise measurement to date. In Figure 1 (a) and (b), the optimal binning scheme and the result are shown. With the study of , simulation samples that have negligible statistical uncertainty, the propagated uncertainty from the measured from optimal binning scheme to is found to be () based on constrained (unconstrained) results. The first measurement with the upgraded LHCb detector [5] has already used the parameters without the model assumption, so its input is free from amplitude-model dependence.
Figure 1. For strong-phase analysis, from left to right: (a) Optimal binning scheme (), and (b) in this scheme from 7.93 fb, without (red) and with (green) the model link to , and the model prediction (blue) [3]. (c) Strong-phase difference and (d) optimal weight , which define the per-event weights [6].
Unbinned measurement: determination of optimal Fourier weights
Binning averages the interference inside each bin, and the current binning schemes keep about of the statistical sensitivity to . The joint BESIII and LHCb analysis uses the optimal Fourier weights and [7]. Here, is the strong-phase difference at a Dalitz plot point , and the optimal weights include the amplitude ratio, efficiency and background effects. The Dalitz plot distribution of and are shown in Figure 1 (c) and (d) respectively. Both optimal weight and are predicted from an amplitude model, however, the weighted integrals are determined from data. A poor model only dilutes the sensitivity but does not bias the result itself. At BESIII, these weighted integrals have been measured with 8 fb decays. LHCb can then use this information to measure the weighted () yields with 9 fb of collision data. A simultaneous fit with Fourier expansion for and for gives [6] (Figure 2(a)), which is the most precise single measurement to date. Compared with the previous measurement that uses the same LHCb data [8], this measurement improves the statistical precision on by 5%, and reduces the uncertainty due to the BESIII input to 0.6°.
Figure 2. From left to right: (a) two-dimensional 68% and 95% confidence-level (CL) contours of from the joint BESIII and LHCb unbinned analysis [6]. (b) Measured of in the four bin pairs (black, 68% CL, statistical only) compared with the amplitude-model prediction (blue crosses) [10]. , for decay modes of (c) and (d) , from the global fit. The black lines show the earlier 2.93 fb result [12].
First model-independent strong-phase measurement of decay
The decay has been studied by the LHCb Collaboration and found to provide interesting sensitivity to [9]. Similar to the decay, the strong-phase differences of decay can be measured in phase-space bins. The binning has been done by defining: , , and therefore the five-dimensional phase space can be projected into a two-dimensional surface. With 20.3 fb of data, the first model-independent measurement of the binned strong-phase difference for has been reported [10] (Figure 2(b)), this is consistent with the model predicted value. This analysis also gives the -even fraction , where the first uncertainty is statistical and the second is systematic. For a sample with a size equivalent to LHCb Run 1 and Run 2, the contribution to is about 10°, as a reference the statistical uncertainty of the itself is 12.7°. The LHCb experiment reported its first model-independent binned analysis of and decays using this result, and gives [11].
Coherence factors and strong-phase differences in () decays
The decay and decay are an important category of charm decays and they provide unique sensitivity for measurement. These quasi-flavour decay modes combine both Cabibbo-favoured and doubly Cabibbo-suppressed amplitudes, and the interference can be measured as . Here, is the coherence factor and is the strong-phase difference for decay mode . With 7.93 fb of quantum-correlated data, BESIII obtains , , and [12]. The uncertainty on is two to three times smaller than in the CLEO-c and earlier BESIII results (Figure 2(c,Figure 2d)).
The parameters are also measured in four phase-space bins, this is benefiting from the large local coherence effect up to , from the overlapping resonance contributions. This enables a stand-alone determination of . With the 9 fb LHCb sample, its expected uncertainty is , of which comes from the BESIII inputs.
C-even above threshold: a new source of correlated pairs
On and above the threshold, pairs are produced with photons and neutral pions. When these consist of photons or any number of the , the pairs are then expected to have an eigenvalue of [13]. The BESIII experiment fully reconstructed both mesons and explored five different production mechanisms, using 7.13 fb data sample at – GeV, for the quantum-correlation studies. The productions of , , with , and , with are studied with the missing energy and mass. As shown in Figure 3, the efficiency-corrected yields match the prediction well, which leads to the first observation of the -even quantum-correlation in the processes [13, 14].
Figure 3. The ratios of efficiency-corrected yields observed in data to those expected in the absence of correlations and mixing for each final state originating from each production mechanism. The displayed errors include systematic uncertainties [13].
The strong-phase differences can then be measured with these data set, giving , where the first uncertainty is statistical and the second is systematic [14]. This result agrees with the previous BESIII measurement [15], with a three times smaller systematic uncertainty, and the combination of the two measurements is . Moreover, the -even decay rates have a linear relation to the mixing parameters and , which gives a promising sensitivity for the time-integrated mixing measurements at colliders. The study with a predicted 1 ab data at each of four energies from 4.01 to 4.26 GeV at a future super tau-charm facility gives and [13], comparable to the present world averages.
Summary
The BESIII experiment has provided important strong-phase inputs to -violation studies, most notably the determination of the CKM angle . Novel methods such as the unbinned strong-phase parametrisation and the exploitation of -even correlations in data significantly improve both statistical and systematic uncertainties. A summary of the results quoted in this report is shown in Table 1. Future measurements with improved analysis methods and increased datasets are expected to push the precision further.
| Mode | Observable | Integrated luminosity () | |
| in bins | 7.93 | – | |
| Optimal Fourier weights | 8 (+LHCb 9) | ||
| in bins, | 20.3 | ||
| , (global and in 4 bins) | 7.93 | ||
| , | 7.93 | – | |
| 7.13 | – |
Table 1. Results reviewed here. is the contribution of the BESIII inputs to the uncertainty on , as estimated in each paper.
References
- [1]LHCb Collaboration, “Simultaneous determination of the CKM angle γ and parameters related to mixing and CP violation in the charm sector“, LHCb-CONF-2025-003, doi:10.17181/CERN.GFHE.LM6W.DOI
- [2]LHCb Collaboration, “Observation of the mass difference between neutral charm-meson eigenstates“, Phys. Rev. Lett. 127 (2021) 111801.DOI
- [3]BESIII Collaboration, “Updated model-independent measurement of the strong-phase differences between D⁰ and D̄⁰ → K⁰S/π⁺π⁻ decays,” JHEP 06 (2025) 086.
- [4]BESIII Collaboration, “Model-independent determination of the relative strong-phase difference between \(D^0\) and \(\bar D^0 \to K_S^0\pi^+\pi^-\) and its impact on the measurement of the CKM angle \(\gamma/\phi_3\),” Phys. Rev. D 101 (2020) 112002; BESIII Collaboration, “Determination of strong-phase parameters in \(D \to K_S^0\pi^+\pi^-\),” Phys. Rev. Lett. 124 (2020) 241802.
- [5]LHCb Collaboration, “Measurement of \(\gamma\) using \(B^\pm \to DK^\pm\) and \(B^\pm \to D\pi^\pm\) decays with \(D \to K_S^0\pi^+\pi^-\) and \(D \to K_S^0K^+K^-\),” JHEP 08 (2026) 037.
- [6]BESIII and LHCb Collaborations, “Measurement of the CKM angle \(\gamma\) in \(B^\pm \to D(\to K_S^0h'^+h'^-)h^\pm\) decays with a novel approach,” Phys. Rev. D (accepted), arXiv:2604.05701; BESIII and LHCb Collaborations, “Precise measurement of the CKM angle \(\gamma\) with a novel approach,” Phys. Rev. Lett. (accepted), arXiv:2604.05712.arxiv.org/abs/2604.05701
- [7]A. Poluektov, “Unbinned model-independent measurements with coherent admixtures of multibody neutral \(D\) meson decays,” Eur. Phys. J. C 78 (2018) 121.DOI
- [8]LHCb Collaboration, “Measurement of the CKM angle \(\gamma\) in \(B^\pm \to DK^\pm\) and \(B^\pm \to D\pi^\pm\) decays with \(D \to K_S^0h^+h^-\),” JHEP 02 (2021) 169.DOI
- [9]LHCb Collaboration, “A study of \(CP\) violation in the decays \(B^\pm \to [K^\mp K^\mp\pi^\pm\pi^\mp]_Dh^\pm\) (\(h=K,\pi\)) and \(B^\pm \to [\pi^+\pi^-\pi^+\pi^-]_Dh^\pm\),” Eur. Phys. J. C 83 (2023) 547.
- [10]BESIII Collaboration, “Measurement of the strong-phase difference between \(D^0\) and \(\bar D^0 \to K^+K^-\pi^+\pi^-\) in bins of phase space,” Phys. Rev. D 112 (2025) 012015.DOI
- [11]LHCb Collaboration, “A model-independent measurement of the CKM angle \(\gamma\) in the decays \(B^\pm \to [K^+K^-\pi^+\pi^-]_Dh^\pm\) and \(B^\pm \to [\pi^+\pi^-\pi^+\pi^-]_Dh^\pm\) (\(h=K,\pi\)),” JHEP 01 (2026) 062.
- [12]BESIII Collaboration, “Improved measurements of the coherence factors and strong-phase differences in \(D \to K^-\pi^+\pi^+\pi^-\) and \(D \to K^-\pi^+\pi^0\) with quantum-correlated \(D\bar D\) decays,” JHEP 08 (2026) 038.DOI
- [13]BESIII Collaboration, “First observation of quantum correlations in \(e^+e^- \to XD\bar D\) and \(C\)-even constrained \(D\bar D\) pairs,” Phys. Rev. Lett. 135 (2025) 171901.
- [14]BESIII Collaboration, “Novel measurement of the strong-phase difference between \(D^0 \to K^-\pi^+\) and \(\bar D^0 \to K^-\pi^+\) decays using \(C\)-even and \(C\)-odd quantum-correlated \(D\bar D\) pairs,” Phys. Rev. D 112 (2025) 072006.
- [15]BESIII Collaboration, “Improved measurement of the strong-phase difference \(\delta_D^{K\pi}\) in quantum-correlated \(D\bar D\) decays,” Eur. Phys. J. C 82 (2022) 1009.


