WorksPhysics and Astronomy
Competing superconductivity and charge-density wave in Kagome metal CsV3Sb5: evidence from their evolutions with sample thickness
Abstract
Recently superconductivity and topological charge-density wave (CDW) were discovered in the Kagome metals VSb ( = Cs, Rb, and K), which have an ideal Kagome lattice of vanadium. Here we report resistance measurements on thin flakes of CsVSb to investigate the evolution of superconductivity and CDW with sample thickness. The CDW transition temperature decreases from 94 K in bulk to a minimum of 82 K at thickness of 60 nm, then increases to 120 K as the thickness is reduced further to 4.8 nm (about five monolayers). Since the CDW order in CsVSb is quite three-dimensional (3D) in the bulk sample, the non-monotonic evolution of with reducing sample thickness can be explained by a 3D to 2D crossover around 60 nm. Strikingly, the superconducting transition temperature shows an exactly opposite evolution, increasing from 3.64 K in the bulk to a maximum of 4.28 K at thickness of 60 nm, then decreasing to 0.76 K at 4.8 nm. Such exactly opposite evolutions provide strong evidence for competing superconductivity and CDW, which helps us to understand these exotic phases in VSb Kagome metals.
The thickness of the CsVSb thin flakes was determined by Atomic Force Microscopy (AFM) (Park NX10). The resistance measurements of the thin flakes were performed in a physical properties measurement system (PPMS, Quantum Design) and a He refrigerator. All the loading processes out of the glove box were done within one minute to prevent sample from degradation.
As plotted in Figure 1(a), CsVSb consists an ideal Kagome lattice of vanadium coordinated by antimony, with the alkali-metal atoms of Cs intercalated between each layer. The lattice parameters are Å and Å [1]. The single crystal can be easily exfoliated to tens of nanometers by using conventional scotch tape and PDMS films, however such method is difficult to obtain even thinner flakes of CsVSb sample. With the help of AlO, high-quality CsVSb single crystal can be exfoliated to a few nanometers so that our study can go down to several monolayers. A typical optical image of a CsVSb thin flake device is shown in Figure 1(b). Transparent AlO on SiO/Si substrate manifests green because of diffraction. The yellow part on the AlO is the sample area. A standard four-probe method is used in the resistance measurement. The schematic device structure is plotted in Figure 1(c). The thickness of the sample was determined by AFM in the selected area marked by red box in Figure 1(b), along the white
Figure 1. (a) Crystal structure of CsVSb. The layers consisting ideal Kagome lattice of vanadium coordinated by antimony are separated by the alkali-metal atoms of Cs. The lattice parameters are Å and Å [1]. (b) Optical image of a thin CsVSb flake device. Cr/Au contacts were deposited on the sample through the stencil mask for four-probe measurements. The scale bar is 40 m. (c) Schematic structure of CsVSb device and measurement set-up. (d) Atomic force microscopy image of the area marked by the square in (b). The scale bar is 1 m. (e) Cross-sectional profile of the thin flake along the white line in (d). The step is about 4.8 nm in height which corresponds to five CsVSb monolayers.
line which crosses the edge of the sample in AFM image shown in Figure 1(d). The AFM measurement gives the thickness of this flake is about 4.8 nm (Figure 1(e)), corresponding to five monolayers.
Temperature dependence of the resistance for CsVSb thin flakes with various thickness, from bulk single crystal to 4.8 nm, are shown in Figure 2. The data are normalized by the values at 290 and 140 K for (a) and (b), respectively. The curves are vertically shifted for clarity. The arrows mark the CDW transition temperature . For the bulk single crystal, K is consistent with previous report [3]. With decreasing of the thickness, decreases from 94 K in bulk to a minimum of 82 K at thickness of 60 nm, then increases to 120 K as the thickness is further reduced to 4.8 nm (about five monolayers). Such a non-monotonic evolution of with sample thickness in CsVSb is quite unusual. To our knowledge, only VSe was reported to manifest this kind of non-monotonic thickness dependent of [18]. It was attributed to the crossover in the Fermi surface topology from 3D to 2D around 20 nm [18]. For bulk CsV₃Sb₅, superstructure [19] and [12] superstructure were reported, by means of X-ray diffraction, suggesting 3D CDW. Therefore, the non-monotonic evolution of with sample thickness in CsV₃Sb₅ may be also due to a crossover from 3D to 2D around 60 nm. Note that 60 nm is actually quite thick, far from the 2D limit.
Figure 2. Temperature dependence of the resistance for CsVSb thin flakes with various thickness, from bulk single crystal to 4.8 nm. The data are normalized by the values at 290 and 140 K for (a) and (b), respectively. The curves are vertically shifted for clarity. The arrows mark the CDW transition temperature . For the bulk single crystal, K is consistent with previous report [3].
Figure 3(a) plots the low-temperature resistance below 5 K, to show the superconducting transitions. The superconducting transition temperature is defined as the 10% drop of the normal-state resistance. It is found that the first increases from 3.64 K in bulk to a maximum of 4.28 K in the 60 nm sample, then decreases to 0.76 K in the 4.8 nm sample. To confirm that the resistance drop in the 60 nm sample is an enhanced superconducting transition, various magnetic fields are applied, as seen in Figure 3(b). The resistance drop is suppressed with increasing magnetic field, confirming that it is a superconducting transition. The temperature dependence of upper critical field is plotted in the insets of Figure 3(b). The data can be well fitted by the Ginzburg-Landau (GL) formula , giving T. This value is much higher than that of bulk single crystal [7]. It is worthy to note that the superconducting transition become sharper with the decreasing of the sample thickness.
Figure 3. (a) The low-temperature resistance for CsV₃Sb₅ thin flakes with various thickness, normalized by the values at 140 K. The curves are vertically shifted for clarity. (b) Superconducting transitions of the 60 nm CsV₃Sb₅ flake under various perpendicular magnetic fields up to 1.5 T. The inset shows temperature dependence of the upper critical field . Red line marks the fitting of Ginzburg-Landau theory.
Based on above resistance measurements of CsV₃Sb₅ thin flakes, the evolutions of and are plotted in Figure 4. One can see that shows an exactly opposite evolution, compared with that of . Such exactly opposite evolutions provide strong evidence for competing superconductivity and CDW in CsV₃Sb₅.

Figure 4. The evolutions of superconductivity and charge-density wave with sample thickness in CsV₃Sb₅. The charge-density wave transition temperature decreases first, then increases as the sample thickness is further reduced. Such a non-monotonic evolution can be explained by a 3D to 2D crossover around 60 nm. At the mean time, the superconducting transition temperature of CsV₃Sb₅ shows an exactly opposite evolution with sample thickness. This provides strong evidence for competing superconductivity and charge-density wave in CsV₃Sb₅.
In summary, we investigate the dimensionality effect on superconductivity and CDW of the new Kagome metal CsV₃Sb₅ by electrical transport measurements. The opposite non-monotonic evolutions of superconductivity and CDW with the sample thickness give strong evidence for competing superconductivity and CDW. The non-monotonic evolution of with reducing sample thickness can be explained by a 3D to 2D crossover around 60 nm. More theoretical calculations and experimental works are needed to clarify the underlying physics of this kind of competition.
This work was supported by the Natural Science Foundation of China (Grant No. 12034004), the Ministry of Science and Technology of China (Grant No.: 2016YFA0300503), and the Shanghai Municipal Science and Technology Major Project (Grant No. 2019SHZDZX01). Y. F. Guo was supported by the Major Research Plan of the National Natural Science Foundation of China (No. 92065201) and the Program for Professor of Special Appointment (Shanghai Eastern Scholar). H. C. Lei was supported by National Natural Science Foundation of China (Grant No. 11822412 and 11774423), the Ministry of Science and Technology of China (Grant No. 2018YFE0202600 and 2016YFA0300504), and Beijing Natural Science Foundation (Grant No. Z200005).
B. Q. Song, X. M. Kong, W. Xia, and Q. W. Yin contributed equally to this work.
† E-mail: [email protected]
‡ E-mail: [email protected]
‡ E-mail: [email protected]
∗ E-mail: [email protected]
References
References
- [1]B. R. Ortiz, L. C. Gomes, J. R. Morey, M. Winiarski, M. Bordelon, J. S. Mangum, I. W. H. Oswald, J. A. Rodriguez-Rivera, J. R. Neilson, S. D. Wilson, E. Ertekin, T. M. McQueen, and E. S. Toberer, New Kagome prototype materials: discovery of KV₃Sb₅, RbV₃Sb₅, and CsV₃Sb₅. Phys. Rev. Mater. 3, 094407 (2019).
- [3]B. R. Ortiz, S. M. L. Teicher, Y. Hu, J. L. Zuo, P. M. Sarte, E. C. Schueller, A. M. M. Abeykoon, M. J. Krogstad, S. Rosenkranz, R. Osborn, R. Seshadri, L. Balent, J. He, and S. D. Wilson, CsV₃Sb₅: A Z₂ topological Kagome metal with a superconducting ground state. Phys. Rev. Lett. 125, 247002 (2020).
- [7]C. C. Zhao, L. S. Wang, W. Xia, Q. W. Yin, J. M. Ni, Y. Y. Huang, C. P. Tu, Z. C. Tao, Z. J. Tu, C. S. Gong, H. C. Lei, Y. F. Guo, X. F. Yang, and S. Y. Li, Unconventional superconductivity in the topological Kagome metal CsV₃Sb₅, arXiv: 2102.08356 (2021).
- [12]B. R. Ortiz, S. M. L. Teicher, L. Kautzsch, P. M. Sarte, J. P. C. Ruff, R. Seshadri, and S. D. Wilson, Fermi surface mapping and the nature of charge density wave order in the kagome superconductor CsV₃Sb₅. arXiv: 2104.07230 (2021).DOI
- [18]Á. Pásztor, A. Scarfato, C. Barreteau, E. Giannini, and C. Renner, Dimensional crossover of the charge density wave transition in thin exfoliated VSe₂, 2D Mater. 4 041005 (2017).
- [19]H. X. Li, T. T. Zhang, Y.-Y. Pai, C. Marvinney, A. Said, T. Yilmaz, Q. Yin, C. Gong, Z. Tu, E. Vescovo, R. G. Moore, S. Murakami, H. C. Lei, H. N. Lee, B. Lawrie, and H. Miao, Observation of unconventional charge density wave without acoustic phonon anomaly in Kagome superconductors AV₃Sb₅ (A = Rb,Cs), arXiv:2103.09769 (2021).DOI


