WorksPhysics and Astronomy
Charged-particle production in pp collisions at = 13.6 TeV and PbPb collisions at = 5.36 TeV with ALICE
Abstract
This article presents the measurement of charged-particle pseudorapidity () density, , in protonproton (pp) collisions at a centre-of-mass energy = 13.6 TeV, and in leadlead (PbPb) collisions at a centre-of-mass energy per nucleon pair = 5.36 TeV. The analysis is performed using the Run 3 data recorded during 2022 and 2023 by the upgraded ALICE detector. The charged-particle multiplicity is measured at midrapidity () using the new monolithic active pixel sensors-based Inner Tracking System and the Time Projection Chamber upgraded with Gas Electron Multiplier-based readout system. The measurements in pp collisions are reported for inelastic events with at least one charged particle having whereas for PbPb collisions, the is obtained for different centrality classes, ranging from 05% (most central) to 7080% (most peripheral). The energy dependence of average charged-particle pseudorapidity density () measured in is studied and compared to earlier measurements at lower collision energies. In PbPb collisions, the evolution of as a function of the average number of participating nucleons, , determined with a Glauber model, is also studied and compared with predictions from theoretical models.
© Copyright owned by the author(s) under the terms of the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License (CC BY-NC-ND 4.0). https://pos.sissa.it/
Introduction
The pseudorapidity density of charged particles () produced in the central rapidity region is a key observable to investigate the underlying mechanisms of particle production and to characterise properties, such as the initial gluon and energy density, of the matter created in high-energy nuclear collisions. At collider energies, the production of final-state particles is driven by the interplay of soft and hard quantum chromodynamics (QCD) interactions and is sensitive to non-linear QCD evolution in the initial state. The study of and its dependence on colliding system, centre-of-mass energy, and collision geometry is essential to understand the relative contributions of these interactions to the final-state particle production. Moreover, measurement of this fundamental observable provides important constraints to model calculations based on different particle production mechanisms and initial conditions.
In this article, we report on the study of the charged-particle pseudorapidity density in pp collisions at TeV and in Pb–Pb collisions at TeV, utilising the data taken with the ALICE detector. The average charged-particle density, , is measured in the pseudorapidity interval , where is the polar angle between the charged-particle direction and the beam axis (). The data are compared to model predictions and previous measurements at lower centre-of-mass energies. Our result provides new insight into particle production mechanisms in pp and Pb–Pb collisions at the highest ever centre-of-mass energies achieved at the LHC.
Experimental setup
During the LHC Long Shutdown 2 (2019-2022), the ALICE detector underwent a significant upgrade that has led to a new experimental setup which is capable of recording data of Pb–Pb collisions at rates up to 50 kHz [1]. The major upgrades include shifting to continuous data-taking mode, upgrading several sub-detectors, and developing a new online-offline (O) software framework for online and offline data processing, as well as physics analysis.
The main sub-detectors used in this analysis are the upgraded Inner Tracking System (ITS) and the Time Projection Chamber (TPC), and the newly installed Fast Interaction Trigger (FIT). The new ITS [2] consists of seven cylindrical layers equipped with silicon monolithic active pixel sensors, providing better pointing resolution thanks to its reduced distance to the interaction point (IP) and better position resolution compared to the ITS used in Runs 1 and 2. The upgraded TPC [3] employs new readout chambers based on Gas Electron Multiplier (GEM) foils that minimise the ion backflow and the resulting space charge effects in the TPC. This allows the TPC to operate at interaction rates up to 50 kHz for Pb–Pb collisions. In this analysis, the ITS and TPC detectors are used to measure charged particles at midrapidity. The FIT detector [4] consists of five distinct detector stations grouped into three sub-detectors (FT0, FV0, FDD) installed on both sides (A and C side) of the IP. This analysis uses FT0 for triggering, event selection, and centrality determination.
Event selection and data analysis
A set of event selection conditions have been considered in this analysis. Events are selected based on their timing relative to the bunch crossing and the corresponding FT0 signal. Events which are close in time to the ITS readout time frame borders are not considered. Events where the vertex position estimated from the FT0 is more than 1 cm away from the vertex position determined from TPC and ITS tracks are also removed from the analysis. The selected events are further required to have a reconstructed vertex within cm from the nominal IP along the axis.
Centrality classes in Pb–Pb collisions are determined by fitting the measured FT0 amplitude on the C side, , (see Figure 1) with a Glauber Monte Carlo (MC) model [5] coupled with a negative binomial distribution (NBD), following the method developed previously [6]. The average number of participating nucleons in a given centrality class, , reflects the collision geometry and is obtained using the Glauber calculation by classifying events according to the impact parameter.

Figure 1. Distribution of the FT0C amplitude measured in Pb–Pb collisions at TeV. The distribution is fitted with the Glauber MC combined with a NBD, shown as a red line. Centrality classes are also indicated by vertical lines.
The charged-particle tracks for the analysis are categorised into global tracks, ITS-only tracks, and TPC-only tracks. Global tracks are the best quality tracks that are matched between ITS and TPC. The TPC-only tracks are excluded from the analysis due to insufficient pointing resolution when propagated to the vertex and significant secondary particle contamination. The tracks considered in this study include global tracks requiring to pass quality cuts for ITS and TPC contributions, and ITS-only tracks passing quality cuts for ITS contributions. Both types of selected tracks are further required to satisfy a criterion on distance of closest approach to ensure they originate from primary particles.
The raw obtained from the number of selected tracks within is corrected for the detector acceptance and the efficiency of a primary particle to produce a track using Pythia 8/Angantyr [7] MC event generator, following the method described in Ref. [8]. Systematic uncertainties from various sources (extrapolation to zero transverse momentum, particle composition, variations in detector acceptance, uncertainty on the centrality determination, variations in track selection) are evaluated and then added in quadrature to obtain the total systematic uncertainty. For pp, the total systematic uncertainty amounts to , while for Pb–Pb, the total systematic uncertainty is () for the most central (most peripheral) collisions. The statistical uncertainties are found to be negligible.
Results and discussion
pp collisions at TeV
The resulting pseudorapidity density distribution of charged particles in pp collisions is presented in Figure 2 (left). The distribution is measured for inelastic (INEL) pp events having at least one charged particle produced in the interval (INEL0 event class). The data are compared to prediction from MC event generator Pythia 8 with the Monash 2013 tune [9], showing that Pythia 8 reproduces the measurements well. In the central rapidity region (), the is which gives 10% increase of charged-particle multiplicity as compared to 13 TeV with [10]. Figure 2 (right) shows the energy dependence of in pp collisions for INEL, non-single diffractive (NSD), and INEL event classes. The lines are power-law fits of the energy dependence of the data for different event classes, and the gray bands represent the standard deviation of the fits. The at 13.6 TeV (solid red star symbol on extreme right) follows the established power-law trend as a function of .

Figure 2. (Left) Distributions of in pp collisions at 13.6 TeV for INEL event class. Data are compared with Pythia 8 (Monash 2013 tune) prediction. (Right) The energy dependence of in pp collisions. Lines indicate fits with a power-law dependence on .
Pb–Pb collisions at TeV
The over in Pb–Pb collisions is measured for nine centrality classes, ranging from 0–5% (most central) to 70–80% (most peripheral). To compare bulk particle production in different collision systems and at different energies, the charged-particle density is divided by the determined for each centrality class. For the most central Pb–Pb collisions, the measured is and normalised per participant pair that corresponds to . In Figure 3 (left), this value (solid red circle) is compared to the central heavy-ion collisions at lower centre-of-mass energies (see [11] and references therein). The recent measurement at TeV by CMS experiment [12] (solid green diamond) is also shown in the figure, which is consistent with our measurement. The dependence of on is fitted with a power-law that gives . This value can be compared to obtained for pp collisions (see Figure 2 (right)) using the same power-law fit function. This shows that the charged-particle multiplicity increases faster with energy in central heavy-ion collisions compared to pp collisions. The results at TeV confirms the trend established by lower-energy data since does not change significantly (earlier we found [11]) when the new point is included in the fit.

Figure 3. (Left) Values of for central heavy-ion collisions as a function of . (Right) Centrality evolution of in Pb–Pb collisions at TeV. Predictions from theoretical models are superimposed.
Figure 3 (right) presents the measured (solid circles) as a function of in Pb–Pb collisions at TeV. The gray bands represent the total systematic uncertainties, and the statistical uncertainties are within the symbol size. A strong centrality dependence is observed, with decreasing by a factor of from the most central collisions, large , to the most peripheral, small . This trend is similar to that previously measured in lower-energy Pb–Pb collisions [11, 13].
The centrality dependence of is also compared to predictions from HYDJET++ (v2.4) MC event generator and to hydrodynamic calculations using IP-Glasma and McDIPPER models. The HYDJET++ [14] describes a heavy-ion collision as a superposition of the soft hydro-type component and the hard component resulting from multiparton fragmentation, treating both components independently. The hard component is described by PYTHIA simulation, while the soft component is modelled as a thermal hadronic state generated on the freeze-out hypersurfaces derived from the parametrisation of relativistic hydrodynamics. Hadron multiplicities are estimated using the effective thermal volume approximation. The IP-Glasma is an initial-state model [15] based on the Color Glass Condensate (CGC) effective theory to describe the initial distribution of gluons in the colliding nuclei at different impact parameters, taking into account the phenomenon of gluon saturation. In this study, we consider a hybrid model [16] consisting of the IP-Glasma initial conditions followed by the MUSIC hydrodynamic model, coupled to a hadronic cascade model (UrQMD). The McDIPPER is also an initial-state model [17], which calculates the energy and charge deposition in heavy-ion collisions based on the leading order cross-section calculations within the CGC framework. The value of is estimated from the initial energy density profile using a hydrodynamical response as outlined in Ref. [18]. As shown in Figure 3 (right), both IP-Glasma+MUSIC+UrQMD (black line) and McDIPPER (blue line) calculations capture the general trend of the data; however, the McDIPPER model provides a better description of the data, particularly in peripheral Pb–Pb collisions, than the IP-Glasma+MUSIC+UrQMD model. HYDJET++ fails to reproduce both the shape and the magnitude of the dependence of multiplicity on centrality.
Summary
In summary, we have reported the measurements of charged-particle pseudorapidity density in pp collisions at TeV and in Pb–Pb collisions at TeV with the ALICE detector at the LHC. The measured charged-particle densities in are and for INEL pp collisions and most central Pb–Pb collisions, respectively. These quantities are in agreement with the expectations from lower energy extrapolations. The centrality dependence of at TeV is found to be similar to that of previously measured lower-energy Pb–Pb collisions. Measurements of this fundamental observable of bulk particle production at new energy regimes can serve as essential inputs for developing theoretical models and MC event generators.
References
- [1]ALICE Collaboration, S. Acharya et al. JINST 19 no. 05, (2024) P05062.
- [2]ALICE Collaboration, B. Abelev et al. J. Phys. G 41 (2014) 087002.
- [3]ALICE TPC Collaboration, J. Adolfsson et al. JINST 16 no. 03, (2021) P03022.
- [4]ALICE Collaboration, W. H. Trzaska Nucl. Instrum. Meth. A 845 (2017) 463–466.
- [5]M. L. Miller et al. Ann. Rev. Nucl. Part. Sci. 57 (2007) 205–243.
- [6]ALICE Collaboration, B. Abelev et al. Phys. Rev. C 88 no. 4, (2013) 044909.
- [7]C. Bierlich, G. Gustafson, L. Lönnblad, and H. Shah JHEP 10 (2018) 134.
- [8]ALICE Collaboration, J. Adam et al. Eur. Phys. J. C 77 no. 1, (2017) 33.
- [9]P. Skands, S. Carrazza, and J. Rojo Eur. Phys. J. C 74 no. 8, (2014) 3024.
- [10]ALICE Collaboration, J. Adam et al. Phys. Lett. B 753 (2016) 319–329.
- [11]ALICE Collaboration, J. Adam et al. Phys. Rev. Lett. 116 no. 22, (2016) 222302.
- [12]CMS Collaboration, A. Hayrapetyan et al. arXiv:2409.00838 [hep-ex].DOI
- [13]ALICE Collaboration, K. Aamodt et al. Phys. Rev. Lett. 106 (2011) 032301.
- [14]I. P. Lokhtin et al. Comput. Phys. Commun. 180 (2009) 779–799.
- [15]B. Schenke, P. Tribedy, and R. Venugopalan Phys. Rev. Lett. 108 (2012) 252301.
- [16]B. Schenke, C. Shen, and D. Teaney Phys. Rev. C 102 no. 3, (2020) 034905.
- [17]O. Garcia-Montero, H. Elfner, and S. Schlichting Phys. Rev. C 109 no. 4, (2024) 044916.
- [18]G. Giacalone et al. Phys. Rev. Lett. 123 no. 26, (2019) 262301.